Home & Security

Ronseal Fence Life Plus+ provides 5 year protection for both rough sawn and smooth planed sheds and fences. It provides all weather and UV protection for long lasting colour.

Fence Life+ can be applied by spray or brush and will stick to damp wood.

PTDGRPRSLFLPPCF5L

Ronseal Shed and Fence Preserver has been specially formulated to give colour and protection to sheds and fences. The deep penetrating 2-in-1 formula eradicates woodworm whilst preserving the wood to prevent rot and decay. The unique formula contains added water repellents, waterproofing the timber from the damage caused by water ingress.

Before You Start: Ensure all surfaces are clean, dry and free from surface coatings such as paint, varnish or stain etc. Where timbers are suffering from decay, before applying Ronseal Shed and Fence Preserver, remove all decayed wood and replace with sound, treated timber. Cut out and burn all decayed wood at least 45cm beyond the area of damage.

Application: Shake well before use. This is important to ensure uniform colour. Ronseal Shed & Fence Preserver can be applied by brush or dipping. Where possible, end grains should be treated by dipping to ensure complete penetration. Apply a minimum of 2 even coats of Ronseal Shed and Fence Preserver, covering all faces, sides and joints, paying particular attention to the end grain. Refer to all coverage guidelines. The second coat should be applied after the first coat is fully dry. Avoid contact with bitumen, bitumen felt or mastics and plastics.

PTDGRPRSLSFAB5L

Ronseal Total Wood Preserver is a general purpose preserver that has been specially formulated to kill woodworm and prevent rot and decay. It is an ideal pre-treatment for interior and exterior wood and suitable for overpainting. Perfect to use on rough or smooth timber.

Coloured preservers are made for outdoors and will colour and protect in all weather. The clear wood preserver does not waterproof and is made for preserving indoor wood.

Before You Start: Ensure all surfaces are clean, dry and free from surface coatings such as paint, varnish or stain etc. Where timbers are suffering from decay, before applying Ronseal Total Wood Preserver, remove all decayed wood and replace with sound, treated timber. Cut out and burn all decayed wood at least 45cm beyond the area of damage.

Application: Shake well before use. Ronseal Total Wood Preserver can be applied by brush, spray or dipping. If applying by spray use a coarse spray and avoid misting. Note that Ronseal Total Wood Preserver is not compatible with Ronseal Sprayers. Where possible end grains should be treated by dipping to ensure complete penetration. Apply a minimum of 2 coats, covering all faces, sides and joints, paying particular attention to the end grain. The second coat should be applied after 24 hours. When second coat is dry, repairs and gluing can be carried out. Avoid contact with bitumen, bitumen felt or mastics and plastics.

PTDGRPRSLWPBK25L

Ronseal Multi-Purpose Wood Treatment is an effective preserver that provides protection against wet rot, dry rot and insect attack. It kills woodworm, wet rot and dry rot and protects against insects. Apply by brush, spray or dipping.

PTDGRPRSLWT25L

Ronseal Chalky Furniture Paint gives a chalk effect with high performance. It protects against wear and tear and will not rub off on touch. No over coating required.

The paint provides a flat matt, chalky finish.

PTDGRPRSLCFPCC750

Ronseal Crystal Clear Outdoor Varnish is perfect if youre looking to varnish wood and keep its natural colour. Itll protect from the weather and doesnt yellow over time like other traditional varnishes. Crystal Clear Outdoor Varnish is rainproof in 1 hour.

Before you start make sure its a warm, dry day (above 10c) and the wood is clean and dry, also make sure you wear a face mask to avoid breathing in any dust.

Prep Stained or Varnished Wood: give the wood a good sand to make sure the varnish sticks. Then give it a clean with white spirit and leave to dry.

Prep New Wood: give the wood a light sand, clean any dirt or dust with white spirit and leave to dry.

Youll need to put on 3 coats leaving 6 hours between coats. Before the final coat lightly sand the wood, this will help the varnish stick and give a smoother finish.

Coverage: 16.0m covered per litre.
Number of coats: 3.
Application: Brush.
Drying Time: 1 hour.

PTDGRPRSLCCODVM250

Ronseal Decking Rescue Paint gives old decking a new lease of life. It fills small cracks, seals down splinters and covers grey wood, making decking look as good as new.

Decking Rescue provides a long-lasting and scuff resistant finish.

Coverage: With 2 coats a 2.5 Litre tub will cover approximately 10m on ridged boards, and 12m on smooth planed boards.

PTDGRPRSLDRPB25L

Ronseal Garden Paint has been designed to add colour to the whole garden, and not just on wood. It can also be used on other garden substrates such as metal (Primer may be needed), terracotta, brick and stone.

Garden paint adds colour, waterproofs, and improves water repellency. Its high solid content leads to a high film build and longer lasting protection. It is rainproof in 1 hour and will resist cracking and peeling.

Available in many colours.

PTDGRPRSLGPBLKB250

The Ronseal Ultimate Protection Hardwood Garden Furniture Oil penetrates the wood to revive colour and replaces the natural oils lost through weathering, making it look like new. It nourishes the wood from the inside out and has a rapid dry time of 2 hours meaning your garden furniture is back in use in no time.

Our Hardwood Oil keeps your garden furniture looking great and youll only have to use it once a year.

How To Use:

First, give the tin a good shake, pour plenty of oil onto your cloth and wipe the oil onto your furniture, making sure you rub it in well, wipe off any excess. To get the best protection use 3 coats, leaving 4 hours between coats. If you get any oil on yourself, wash it off with warm, soapy water.

Over time youll see the colour fade, for the best protection itll probably need doing every 12 months.

Cleaning Up:

Wash your cloths in warm, soapy water before throwing them away. Dont pour any left over oil down the drain or into watercourses. Your local authority may have special ways to get rid of unused products.

Coverage: 6m per Litre.
Dry Time: Rainproof in 2 hours, 4 hours between coats.

PTDGRPRSLUHWGFOC1L

The Ronseal Anti Condensation Paint adds a layer of insulation to help prevent condensation which leads to mould. Once its dry thats it, job done. Unless you want to add some colour. Then you can paint over it any colour your want. Itll still give the same anti-condensation protection.

BEFORE YOU START

Make sure the room is above 10c. Open your doors and windows for ventilation and put down dust sheets to protect anything you dont want to get paint on.

Preparation: Remove any wallpaper and get rid of any loose paint or plaster by giving it a quick sand. Make sure the area youre painting is clean and dry. If youve got mould, get rid of it with our 3in1 Mould Killer. Cover any damp stains with our One Coat Damp Seal.

USING YOUR ANTI-CONDENSATION PAINT

Give it a really good stir. Then use a roller or brush to put it on. Dont brush or roller it out too thinly. After 4 hours put another generous coat on. Itll be touch dry in 1-2 hours. If you want to paint over it, let it dry for 4 hours.

Usage Areas: All indoor walls and ceilings.
Compatibility: Bare and previously painted walls and ceilings.
Clean Up: Clean all brushes in warm, soapy water.
Coverage: 6m per Litre.

PTDGRPRSLACPWM25L

The Ronseal 3 In 1 Mould Killer kills mould instantly, cleans and protects against mould. It breaks down mould and removes it from paint work.

How to Use.

Squeeze the trigger to break the tamper evident seal. Repeatedly squeeze the trigger, applying direct to the surface ensuring it is wetted thoroughly (wear suitable gloves).

Leave for 5 minutes then wipe the surface using a damp cloth or sponge removing the mould. Once the mould has been removed, wipe away any residual grime with a clean damp cloth.

Clean Up Rinse cloths or sponges in warm, soapy water.

Usage Areas: For use in areas where mould is present.
Compatibility: Suitable for use on, bare or previously painted walls and ceilings.
Clean Up: Clean cloths and sponges in warm soapy water.

Available in a bottle (concentrate) or spray.

PTDGRPRSLMKB500

The Ronseal One Coat Damp Seal permanently blocks damp stains on walls and ceilings. You can even put it onto damp walls. It lets trapped moisture escape without causing anymore damage. When its dry you can paint or wallpaper over it.

BEFORE YOU START

Make sure the cause of damp has been fixed. Open your doors and windows for ventilation and put down dustsheets to protect anything you dont want to get paint on.

Preparation: Remove any wallpaper with a scraper and sand off any loose or flaking paint. Make sure the area you are painting is clean, if youve got mould, get rid of it with our 3-in-1 Mould Killer.

You can paint onto damp surfaces, just make sure theyre not dripping wet.

USING YOUR DAMP SEAL

Give the paint a really good stir, then use a roller or brush to put it on. If youre covering a small damp patch, make sure you are painting at least 30cm around the area.

Itll be touch dry in 2 hours. After 4 hours itll be ready to paint or wallpaper over. If the area is prone to mould, you can paint over it with our 6 Year Anti-Mould Paint.

Usage Areas: All indoor walls and ceilings
Compatibility: Bare or previously painted walls and ceilings
Clean Up: Clean all brushes or rollers in warm, soapy water
Coverage: 5m per litre

PTDGRPRSLOCDSW250

Ronseal Ultimate Protection Decking Oil provides superior, natural looking protection, for a longer lasting finish. The unique formula penetrates deeper into the wood to provide increased durability. Providing a lightly tinted finish it will give double the weather resistance and foot traffic protection versus standard decking oils. Unique, new to the market, water-based Linseed Oil technology, colours and waterproofs your deck in one easy step.

Gives a more natural look to your deck and is rainproof in 90 minutes, recoat in 4 hours. Primarily for use on pre-treated decking.

Preparation -

Untreated, weathered decking:
For untreated grey and weathered wood, use Ronseal Decking Restorer to restore the decks natural colour and provide a sound base for application which ensures the oil penetrates effectively.

Previously finished decking:
Use Ronseal Decking Cleaner and Reviver to remove any dust, grease, oil, mildew, algae and other contaminants. Remove any loose, flaking or peeling coatings. To avoid patchiness, and if using a contrasting colour, make sure you remove all previous finishes using Ronseal Decking Stripper. Ensure cut ends are adequately protected using Ronseal Decking End Grain Preserver.

New wood:
New decking should be allowed to weather naturally (usually 6 months). This will make sure any pre-treatment has eroded allowing the stain to penetrate and adhere to the deck. Clean the deck with Ronseal Decking Cleaner and Reviver using a scrubbing brush to open the pores of the wood and remove any contamination from the manufacture of the timber. Rinse thoroughly with clean water ideally using a pressure washer. Allow to dry fully before over coating.

Test effectiveness of the cleaning by splashing the deck with water. If beading occurs, re-clean. Retest before applying any oil. The shade label indicates approximate colour only. It is recommended that you test a small area to determine the final colour which may be influenced by the texture, grain, colour, porosity, type of wood and any previous treatment.

PTDGRPRSLUDSMG25L

Ronseal One Coat Stain Guard is a clear coat the protects paint from stains. It is ideal for areas that are always getting dirty, marked or stained. It provides a tough, scrubbable finish and does not discolour.

Usage: All interior walls and ceilings.
Compatibility: Previously painted walls and ceilings.
Coverage: 24m per litre.

PTDGRPRSLSGCCM750

Ronseal Interior Wood Wax gives Diamond Hard protection; this means it will protect wood against knocks, scuffs and scratches.

Interior Wood Wax is lightly tinted and comes in a matt finish. Unlike other waxes, it can be applied using a brush, without the need of buffing between coats.

Ronseal Interior Wax Protects like a varnish, with the natural feel of a wax. It is suitable for use on interior furniture and doors.

Drying time: 20 minutes.
Re-coat: 1 hour.
Coverage: 20.0m per litre.

PTDGRPRSLIWAP750