Home & Security

Rustins Gloss Paint is a water-based hard-wearing paint for interior and exterior use. It is suitable for use on wood and metal and conforms to the Toys (Safety) Regulations 1995, BS:EN71 Part 3.

Touch dry in approximately 30 minutes.

PTDGRPRUSBGWB1L

The Rustins Quick Dry Chalky Finish Paint is designed to revive and give your furniture a new lease of life. Suitable for use on interior work, it contains wax and dries to a velvety flat matt finish.

Very little preparation is required to receive the desired look as it can be painted over most previously coated items. If using over a previously coated surface, test a small area for compatibility. Use on bare wood, hardboard, MDF, plaster, brickwork and cement to produce a smooth touch flat matt finish. (Not for direct application to metals). Can also be used as a finish coat over existing wood and metal primers and paints.

Get the shabby chic look by painting your furniture with multiple coats then distressing it by lightly sanding down small areas using fine sandpaper or steel wool.

Specification:

Coverage Approximately: 13m per litre
Coats: 1 coat over primed surfaces, 2 coats (minimum) are required on bare substrates
Drying Time: Touch Dry 30 minutes, depending on temperature and humidity
Re-coating Time: 2 hours minimum, depending on temperature and humidity
Application Temp: Ideally 15-25C. Do not use below 10C or in conditions of high humidity

PTDGRPRUSCPC250

Rustins Quick Dry White Wood Dye is a low odour water based dye to transform the colour of wood. It is touch dry in 30 minutes and can be over-coated after 2 hours with any of the Rustins range of finishes.

It is suitable for all types of wood, hardboard, MDF and cork. The colour is fade resistant and will enhance the natural grain of wood.

The wood must be clean, dry and free of wax, previous coatings and contaminants. Using a rag or brush, apply an even coat and wipe off any excess. Can be diluted with water but do not exceed a 30% dilution. Before use check that the colour is what is required. Do not mix with white spirit or solvent.

Coats: Usually 1 application is sufficient, or 2 for a lighter/whiter shade.

PTDGRPRUSWDWH1L

Rustins Quick Dry Brick & Tile paint is a high-quality acrylic, matt red paint for use on all interior and exterior brickwork. It is pigmented with micronised red oxide to give a good opacity and good exterior durability.

To apply, use a large brush and apply evenly, making sure all the surface area is covered. One coat is usually sufficient with a drying time of 30 minutes, depending on the temperature and humidity.
Apply paint ideally at between 15 - 25C, do not apply if rain is imminent.

Drying time: 30 minutes
Recoat: 4 hours
Coverage: 14m/L

PTDGRPRUSBTPMR250Q

Rustins Quick Dry Red Oxide Primer can be used on all bare metal surfaces, interior and exterior. It is formulated with acrylic and special anti-corrosive pigments to prevent corrosion.

Apply using a quality brush. One coat is normally sufficient, but second coat may be applied if required. The surface may be cleaned with a mild detergent solution or white spirit as necessary. Must be over painted with an undercoat before applying a top coat. Stir well before use.

Dry time: Approx 30 minutes, depending on temperature and humidity.
Recoat: Approx 4 hours.
Coverage: 12-15m per 1 litre.

PTDGRPRUSROMP250Q

Rustins Quick Dry Step & Tile Paint is a high-performance interior and exterior gloss paint for tiles, concrete and bricks. It is quick drying, hard-wearing and weather-resistant.

Not recommended for use on glazed or quarry tiles.

To apply, use a good quality brush. 2 coats are usually sufficient. Sand lightly between coats if needed. Do not apply outdoors if rain is imminent, and do not use below 10C.

Drying time: Approx 4-8 hours
Recoat: 6-8 hours
Coverage: 14m/L

PTDGRPRUSSTP250Q

Rustins Sanding Sealer is manufactured from Pure Shellac and alcohol with a special additive included to facilitate sanding when dry.

It is also used to seal wood before waxing and to seal wood dyes to prevent bleeding.

PTDGRPRUSSS500ML

Rustins Quick Dry Masonry Paint is a high quality, acrylic paint which is suitable for dry exterior masonry surfaces.

To apply, use a large brush and apply evenly. The surface area must be clean, dry, free from dust and other contaminants likely to affect adhesion. No primer is required if fresh mortar has been applied to pointing. Do not use on damp surfaces.

One coat is usually sufficient.

Drying time: approx 30 mins, depending on temperature and humidity.
Re-coat: 4 hours.
Coverage: 14m per 1 litre.

PTDGRPRUSMASPB250

Rustins Quick-Drying All Surface All Purpose (ASAP) Paint is a water based paint that dries to a satin finish. It resists flaking or peeling because of its flexible capabilities.

ASAP has a low odour and does not require any priming. It is suitable for use on wood, metal, plastic, galvanised steel, uPVC, lead, glass, tiles, plaster, mdf, masonry and melamine.

PTDGRPRUSASAPG250

Rustins Quick Dry Shed and Fence Clear Protector is a high quality acrylic binder that includes fungicides, preservatives and waxes to give all external timber long lasting protection from rot and mould. Exterior Clear is resistant to ultra violet light and fading.

Suitable for fences, sheds, trellis and all garden timber, new or previously treated.

PTDGRPRUSECWP1L